STEPS TO THE ASSEMBLY AND DISASSEMBLY OF A DESKTOP PC

STEPS TO THE ASSEMBLY AND DISASSEMBLY OF A DESKTOP PC

1) Prepare the workplace it is, well lit, at a suitable height, screwdrivers (striae), a small box for events screws, clean, dry hands, next to the guide for mounting the computer. You can also NEED pliers to remove the coils covers the front of your computer and change some bridge.

2) Connections and settings for the motherboard: this is removed and can be placed on a surface. you look at the manual and start to configure the first jumpers if any mo mount the micro, the most fan dicipador and memory as no longer have access to another during assembly.

3) Put the power in their structure

4) Set the plate: to fix the plate to its structure taking into account system or security use poles, place the necessary screws that are 4 or 5 so that the plate is motionless.

5) Assemble the processor: insert the micro plate. if they are a pentium/MMX/K5/K6/K6-2/6X68/MII/WINCHIP and others of this style, used the ZIF (zero insertion force). is inserted at socal.

 6) Mount the memories: there are 3 types:

-SDR-RAM DIMM 168-pin DDR-RAM or 184-pin

DIMM, RAMBUS, we find in some places pentium IV, physically very similar to the above.

SIMM MEMORY MODULES have 2 connection possibilities: 1-for vertical insertion. 2-for diagonal insertion.

7) expancion cards: before inserting them, we must etire plate is in front of the slot where we will insert them. not all slots have the same size. in the AGP slot or PCI graphic card rage in the ICP can also go 3D accelerator card to the SCSI controller and the ISA can go to the modem and sound card.

To insert the card first trente place it in the slot. located once begins to press, but try not to do too much.

 8) Storage Units: to mount the CD-ROM or DVD recording of the holes look a 5.25 "We will make match the screw holes on each side and screw it. Just to do with the drive, but this goes in the 3.5 ". hard disk must be put in a hole the size of the drive, with the exception that the gap must be blind, ie that is not accessible from the front of the box.

9) power cables, are connected in 2 ways, depending on whether the plate and the box is baby AT or ATX. If there will be 2 BABY AT power connectors. these connectors are black wires, which would have to be those of a connector with the other. when inserted into the connector of the motherboard has only one position. If there will be a single ATX connector with a range that is hooked to the connector socket to allow latched

10) LED Connections: The speaker and the power button is usually a series of pins located at the bottom right of the box. (See the manual). cables LEDs (POWER IDE) and speaker (SPEAKER) usually have a black colored wire and a white wire. the colored wire is the most and white the least. colored wires always looking to one side and white on the other. the colored wire faces the PIN1 of these pins.

Power button just plug into the motherboard ATX if this is because if a cable BABY AT proviniente will come out of the power supply.

11) close the box or cabinet, connect the devices.